Led white pool lamp 25W - 378led - 1900lm

Based on 0 reviews. - Write a review

126.98€

Ex Tax: 102.40€

: Express delivery
Model: 01.403
Weight: 0.87kg
Dimensions: 27.50cm x 0.00cm x 0.00cm

Qty

Add to Cart

QUICK ORDER

Add to Wish List Compare this Product

Social Share

LED lamp on a resin board

LED: 378 SMD
Voltage: 12 V AC
Consumption: 25 Watt/1900 lumens

Color: white

Description

The luminaire consists of a high-tech electronically controlled board in various versions of brightness power and colors. They are a perfect replacement for the classic PAR56 bulb without requiring any modification. They do not need mechanical sealing as they are filled with transparent resin. Board dimensions: X 170X25mm. In the RGB version, it is offered with 16 different operating programs, while for their synchronization an external synchronizer is not necessary (supplied as optional equipment).

Installation

All lights must be placed on the wall of the pool at least 30cm and up to 70cm from the surface of the water. All fixtures must be connected to the same transformer and switch. The lamp comes with a 2m (2X1.0) cable. Disassemble its base (cross), place it in the desired position and mark the positions to be drilled. After properly fixing the base wrap the cable around the back of the lamp and tighten it onto the base.

Start

The lights must only be used underwater and placed on the vertical surface of the pool in the case of colored lights 16 programs and combinations are available and selected using the on/off switch. To achieve synchronization connect all the lights to the same switch and from the closed position open and close the switch for three consecutive times and then open the switch. All lights will be transferred to program no.8 from where you can select any with on/off.

Caution

Do not use electronic transformers that may damage the installation. The persons responsible for the installation must have the necessary training. IEC 364-7-702 electromechanical installation standards must be followed. Replacing the board must be done with the supply disconnected and the installer must wear specially grounded shoes and in no case change with bare or wet ends.

Warranty

The manufacturer is bound by a two-year warranty from the date of purchase of the product for any defect in material or method of assembly. The warranty does not cover installation costs and problems caused by misuse, improper installation and especially liability regarding the sealing of the wall or any leaks. Within the normal - permissible limits, 3 burned-out LEDs are considered for each lamp with a power of less than 30 watts. The board has trapped small air bubbles of size less than 9mm2 from its front and back.