Led slim pool 100mm INOX 316-L 99/10w/12 Dc 110x8mm

LED light on a board with resin sealing.

INOX 316 slim 99led 10w/12v DC 1,800 Lumen
Color temperature 2,700k
Available only in cold white.



Installation:
All lights must be placed on the wall of the pool at least 30cm and up to 70cm from the surface of the water. All fixtures must be connected to the same transformer and switch. The lamp comes with a 2m (2X1.0) cable. Disassemble its base (cross), place it in the desired position and mark the positions to be drilled. After properly fixing the base wrap the cable around the back of the lamp and tighten it onto the base. The lights must only be used underwater and placed on the vertical surface of the pool.

Caution!
Do not use electronic transformers that may damage the installation. The persons responsible for the installation must have the necessary training. IEC 364-7-702 electromechanical installation standards must be followed. Replacing the board must be done with the supply disconnected and the installer must wear specially grounded shoes and in no case change with bare or wet ends.

Warranty:
The manufacturer is bound by a two-year warranty from the date of purchase of the product for any defect in material or method of assembly. The warranty does not cover installation costs and problems caused by misuse, improper installation and especially liability regarding the sealing of the wall or any leaks. Within the normal - permissible limits, 3 burned-out LEDs are considered for each lamp with a power of less than 30 watts. The board has trapped small air bubbles of size less than 9mm2 from its front and back.